📢 Voice announcement: “Please turn on power switch.”
If your VR 35 says this message, it means the main power switch is currently off, and the robot cannot operate or charge until it is turned on. This guide explains how to check and activate the power switch properly.
1. Locate the Power Switch
-
The main power switch is located on the side of the robot (near the charging port).
-
It is a two-position switch marked with:
-
“O” for OFF
-
“–” for ON
-
2. Slide the Switch to “–” Position
-
Gently slide the switch from “O” to “–” to turn on the power.
-
When powered on, you should hear a short chime or voice prompt.
⚠️ The robot will not respond to charging or button inputs while the switch is set to OFF.
3. Dock the Robot for Charging
-
Once powered on, place the robot on the charging dock.
-
After a few seconds, it should play the voice prompt: “Start recharge.”
-
The indicator lights will turn on if charging has started properly.
4. Daily Use Tip
-
Keep the power switch ON at all times, even when the robot is docked.
-
Only turn it OFF during long-term storage or transportation.
If the robot still does not respond after turning the switch on, please contact the Floorbotics support team for further assistance.