Quad 800 Removal and installation of the rolling brush’s water-retaining rubber

Tool preparation: One set of hexagon wrenches Accessories: None

Diagram

Core tasks

1. Open the lower access panels on both sides of the product (from rear to front).

2. Open the quick fixture and remove the driven shaft shell of the rolling brush.

3. Unscrew the fixing screws of the rolling brush’s water-retaining rubber clamp on the driven shaft side and replace the water-retaining rubber.

When installing, note that the opening of the sheet should be upward.

After replacement, check that the water-retaining rubber can slide up and down. If not, adjust and install it again.

4. Unscrew the fixing screws of the rolling brush’s water-retaining rubber clamp on the drive shaft side and replace the water-retaining rubber.

After replacement, check that the water-retaining rubber can slide up and down. If not, adjust and install it again.